This is my construction album of my Vans RV-10 aircraft I am building.
I started this project on 10-05-07. Enjoy the album
I decided to put a electric rudder trim on. Here are some photos of how I did it. More to come when complete
Here are some pictures of my elevator construction
Pictures of my tail cone construction.
Just a bunch of pictures of the QB fuse going together
In this section a breif look at building, mounting and attaching the door seals
I have design my own panel for my RV-10. It was designed in Solidworks 3D cad software. I talked to many Rv-10 pilots who were flying and took all there suggestions and wish lists and this is what I came up with. It has everything…
I decided to purchase a aftermarket overhead console.
I had Sue And Bart build my engine at Aero Sport Power
This sections shows the installation I used for all windows. I did not use the standard Weldon 10. I used a Urethane adhesive which was much easier to use with a work time of 25 minutes
and it has a little more flex than the weldo…
This sectiond shows the prep work and painiting of the airframe.
I am going to use a waterbase base coat by PPG with a clearcoat.
These are photos of moving the airplane to the airport.
The final assembly at the airport
On October 26 2009 at 4:30 pm N829GW took to the skies
All dressed up with the wheel pants
This is a fiberglass headliner I made to finish off the rear cabin
top area.